Steel Structure Analyzer NOVOTEST KRC-M2 (Coercive Force Meter)
Steel Structure Analyzer NOVOTEST KRC-M2 is designed for measuring coercive force of metal products in accordance with IEC 60404-7 and is used for non-destructive testing of chemical-thermal, thermal and thermomechanical treatments, evaluation of mechanical properties and residual stresses.
Steel structure analyzer is used for determination of mechanical properties, and measurement the hardness of metal products, as well as measurements of products of ferromagnetic alloys in the presence of correlations between the studied parameters. In addition, the device is used for testing the surface layer of ferromagnetic material for grading the metal in steel grades.
KRC-M2 has an electromagnet transmitter with integrated Hall sensor and removable pole tips.
The operation principle of the device consist of following: initially is performed a magnetization of area of the tested object and after that its subsequent progressive demagnetization by the increasing of the field. Next, it is the fixation of the intensity of magnetic field in accordance with the coercive force of material of tested object and measurement the amplitude of signals from the Hall sensor.
The main area of using the Steel Structure Analyzer NOVOTEST KRC-M2 – is analys the stress-strain state and residual life of pipelines, elevators, cranes and lifts, pressure vessels, steel cables of bridges also it used in engineering and metallurgical industries.
Steel Structure Analyzer NOVOTEST KRC-M2 (Coercive Force Meter)
Gaussmeter (Magnetometer) NOVOTEST MF-1
Gaussmeter (Magnetometer) NOVOTEST MF-1 is designed for rapid non-destructive testing and allows:
- ferromagnetic objects magnetic field analysis including magnetic particle inspection;
- industrial noise levels measure;
- to define technical characteristics of equipment for MPI according to requirements of regulatory and technical documentation;
- residual magnetization level measurement after MPI;
- measure magnetic induction of the various components, devices, products, etc.
Gaussmeter (Magnetometer) NOVOTEST MF-1
Magnetic Flaw Detector (Magnetic Yoke) NOVOTEST MPD-DC
Magnetic Flaw Detector (Magnetic Yoke) NOVOTEST MPD-DC applies in circumstances where the electric equipment mustn’t be used or prohibited by the rules.
Device is used during magnetic particle inspection (where it is applicable) according to ASTM E 709, ASTM E 1444, ASME Section V Article 7 and MIL-STD-1949.
Magnetic Flaw Detector NOVOTEST MPD-DC is used to detect surface and subsurface cracks of all kinds (flake, lack of fusion welded joints, tears etc.) in structures made of ferromagnetic materials.
The device has two permanent magnets placed in a cylindrical shells, which are connected by a flexible magnetic wire, so it can be used for MPI of remote locations, corner welds and other products of various shapes and sizes.
Magnetic Flaw Detector (Magnetic Yoke) NOVOTEST MPD-DC
Magnetic Test Samples
We produce different types of magnetic test saples, such as: bars, plates, disks with different types of cracks.
The test blocks are used for:
- quality comparison of different magnetic powders (particle solutions);
- quality assurance of magnetic powders while working with the testing bench;
- for quality analysis during the magnetic particle testing, also to check the correct dosing of magnetic powder in automatic testing.
MTU Test Block#3
The MTU test block #3 (is the reference block type 1 according to EN ISO 9934-2) is used to verify the indication sensitivity of magnetic particle crack detection agents.
The test block is a disk with two types (large and small) of natural cracks (in both sides).
The large cracks are sanding cracks and the small cracks are tension cracks.
The test block has been magnetized by use of the hole in the middle of the test block. The analys of the test block is made by comparison of the picture with the results of the test block with fluorescent magnetic powder and ultraviolet lamp.